![]() But I'm only able to see traffic on Vlan 1 right now. Image location: /vmfs/volumes/ (volume id)/ convert: vmkfstools -i oldfile.vmdk newfile.vmdk -d thin 2.1. Then convert image to one better suited for use with ESX. ![]() Step 2: Connect to your ESX host via ssh and navigate to directory where you uploaded this image. Vlan 1 is set as the native on the Cisco switch, and I want to be able to see Vlans 2 and 3. Step 1: Upload CHR image to your ESX/ESXi host. My question is, does the CHR still need bridges for each Vlan? Below is the config I made. ![]() I've got the CHR VM up and running with a single network interface connected to a VMware vswitch physically connected to Cisco switch configured as a trunk port with vlan 1 native. I've already set the ESXI host Vswitch and network to promiscuous mode. ![]() Hello, I'm trying out Mikrotik CHR on ESXI 6.7 and running into some questions with VLANs. ![]()
0 Comments
Leave a Reply. |